Air filters · TAF · Great Britain

Air filters for industry and HVAC, from TAF, supplied in Great Britain.

aksutec is the exclusive GB representative of 5M Mühendislik – TAF (Turkish Air Filter), a Turkish manufacturer of air filters. From our base in Enfield, North London, we supply panel, bag, HEPA, compact, activated carbon, high-temperature, metal and fan-coil filters, in standard and custom sizes.

Send the size, the class and the quantity. A person checks the request against the TAF range and replies with what matches. This is not an automatic stock search.

Drawing
AKS-AF
Sheet
06 / 17
Rev
2026-11-16

Eight filter types

Choose by what the air has to be rid of.

Dust points to panel, bag or compact filters. Cleanroom and hospital air points to HEPA. Odour and gas point to activated carbon, heat to high-temperature filters, and grease or coarse debris to washable metal filters. Each type has its own page with construction, uses and questions.

Panel filter with blue pleated media in a metal frame, shown at an angle

Panel filters

Flat pleated panels in a frame, for general ventilation and pre-filtration.

Three bag filters with teal, pink and cream pockets hanging from metal header frames

Bag filters

Deep pockets of filter media on a header frame, for larger airflows.

Deep HEPA filter with a wooden frame and a mini-pleat pack seen from the air-entering face

HEPA filters

Mini-pleat packs for high-efficiency filtration, specified to EN 1822 class.

Compact filter in a metal frame with four V-shaped pleated banks

Compact filters

V-bank construction that packs a large media area into a short housing depth.

Cross-section of a activated carbon filterAIRFLOWDHCARBON BEDMEDIA LAYERFRAMESECTION A–A · ACTIVATED CARBON

Activated carbon filters

A carbon bed between media layers, for odour and gas-phase filtration.

Cross-section of a high-temperature filterAIRFLOWDHSTEEL FRAMEDEEP PLEATSSECTION A–A · HIGH-TEMPERATURE

High-temperature filters

Deep-pleat media with metal separators in a steel frame, for heat.

Metal mesh filter in a metal frame, shown at an angle

Metal filters

Layered mesh in a frame that can be cleaned and used again.

Cross-section of a fan-coil filterAIRFLOWHTHIN PLEATED PANELCOILFANSECTION A–A · FAN-COIL

Fan-coil filters

Thin pleated panels cut to fit fan-coil unit housings.

Reading a class

Two standards cover most enquiries.

ISO 16890 classifies general ventilation filters by the size of the particles they capture. EN 1822, aligned with ISO 29463, classifies high-efficiency filters. The older EN 779 names, such as G4 and F7, still appear on drawings and old orders. Tell us whichever you have and we will match it, and we confirm the exact rating for your order.

Filter classes at a glance
StandardCoversGroups or classes
ISO 16890General ventilation filtersISO Coarse, ePM10, ePM2.5, ePM1
EN 1822High-efficiency filtersE10 to E12, H13 and H14 (HEPA), U15 to U17
EN 779 (withdrawn)Older general filter namesG1 to G4, M5 and M6, F7 to F9

A gas-phase filter such as activated carbon is not classed by particle size at all. For carbon we need the gas or odour you are removing instead.

How to specify

Four details are enough to price a filter.

Send these four and a person can check the request. If one is missing, send what you have: a photo of the old filter and its label often fills the gaps.

  1. 01

    Size

    Width × height × depth in millimetres, for example 592 × 592 × 292. Measure the frame of the old filter or the opening it sits in. If the old filter has been squeezed into its slot, measure the slot. Standard and custom sizes are both possible, so send exact figures.

  2. 02

    Class

    Tell us the class you need (ISO 16890 or EN 1822). If your paperwork uses the older EN 779 names, such as G4 or F7, send those and we will match them. If you do not know the class, send the label of the filter you use now.

  3. 03

    Quantity

    How many of each size, and whether this is a one-off order or a regular one. A mixed list is fine, with one line per size.

  4. 04

    Application and airflow

    What the filter sits in, such as an air handling unit, a fan-coil unit, an oven or a cleanroom ceiling, and the airflow in cubic metres per hour if you have it. Add the temperature, the humidity and anything unusual in the air, such as grease, oil or chemicals.

A person checks every request. We tell you what matches, what differs and what we could not confirm, and we confirm the exact rating for your order.

Filter boxes stacked on a palletPANEL G4COMPACT F9BAG F7BAG F8PANEL M5HEPA H13METALCARBONPANEL F7FILTER CARTONSPALLETFILTER STOCK
Illustration

Filter desk

Send the details. A person replies.

The request form is set to air filters. Choose a type, or leave it on Not sure and describe where the filter goes. Add a photo of the old filter or of its label if you have one.

We check the request against the TAF range and tell you what matches, what differs and what we could not confirm. We reply by phone, WhatsApp or email, whichever you give us.

What do you need?

Send a part number or a photo of the rating plate. A person checks every request; this is not an automatic stock search.

Line stopped? Call first. We will pick up the request below too.

Robot part details
Rating plateoptional
Add a photo of the rating plateJPEG, PNG, WebP or HEIC, up to 8 MB.
More detail (optional)
Machining, cell or fixture details
Drawingoptional
Attach a drawingPDF, STEP, STP, DXF, DWG, PNG or JPG, up to 8 MB.
More detail (optional)
Air filter details
More detail (optional)

For example G4, F7 or H13.

Your details
Add a message

Files up to 8 MB. We use your details only to answer this request.

Questions

Air filters: common questions.

Which filter type do I need?

It depends on what you are removing and what your housing can take. Dust and pollen in ventilation air point to panel, bag or compact filters. Cleanroom and hospital air points to HEPA. Odour or gas points to activated carbon. Heat points to high-temperature filters, and grease or coarse debris points to washable metal filters. If you are not sure, send what the unit is, where it sits and what the old filter looked like, and a person will suggest a type.

What do ISO 16890 and EN 1822 mean on a quotation?

ISO 16890 classifies general ventilation filters by the particle size groups they capture: ISO Coarse, ePM10, ePM2.5 and ePM1. EN 1822 classifies high-efficiency filters, from E10 to U17, with H13 and H14 being the usual HEPA classes. Older enquiries often still use EN 779 names such as G4 or F7. Tell us whichever you have and we will match it to a current class and confirm the exact rating for your order.

Do you supply standard sizes and custom sizes?

Both. Many general ventilation filters follow common modular sizes, and many installations do not, so send the width, height and depth in millimetres, measured from the frame or the housing. We will tell you if your size is a standard one or needs to be made to order.

Who makes the filters?

The filters are made by 5M Mühendislik, trading as TAF (Turkish Air Filter), in Türkiye. aksutec is the representative for Great Britain, based in Enfield, North London, so you deal with a UK contact for the enquiry, the quotation and the delivery.

What do I send to get a quotation?

Send the filter type if you know it, the size as width × height × depth in millimetres, the class you need, the quantity and a line about the application or airflow. A photo of the old filter, or of its label, speeds this up. A person checks the request; there is no automatic price lookup.

Can you match a filter I already use?

Usually, yes. Send the label or the manufacturer reference, and the measured size. We compare the construction, frame, class and depth with what the TAF range offers and tell you what matches, what differs and what we could not confirm.