Air filters · Type 05 of 08

Activated carbon filters

An activated carbon filter removes gases, vapours and odours, not particles. Activated carbon is a highly porous material with an enormous internal surface, and gas molecules stick to that surface as air passes through. The filter holds the carbon, as granules or as a layer, between support layers of media or in a rigid frame.

Drawing
AKS-AF-ACTIVATED-CARBON
Sheet
11 / 17
Rev
2026-11-16
Cross-section of a activated carbon filterAIRFLOWDHCARBON BEDMEDIA LAYERFRAMESECTION A–A · ACTIVATED CARBON
Section through an activated carbon filter. A bed of carbon sits between layers of media. The air passes through the bed and the gas molecules stick to the surface of the carbon. The longer the air stays in the bed, the more is removed.

Construction

How a activated carbon filter is built.

Because it adsorbs rather than traps, carbon has a finite capacity. Once the surface is full, the filter stops removing the gas and may release some of it again. How long a filter lasts depends on the contaminant, its concentration, the airflow, the temperature and the humidity, so no single life figure is honest. We confirm the exact rating for your order.

Activated carbon filters at a glance
RemovesGases, vapours and odours (not particles)
ConstructionGranular or bonded carbon between media layers, or in a rigid cell
What decides lifeContaminant, concentration, airflow, temperature and humidity
Upstream needA particle filter so that dust and grease do not coat the carbon
What we need from youThe gas or odour, airflow, conditions, size, quantity

Performance and care

What to expect, and how to look after it.

Performance and limits

Contact time decides how well carbon works. The longer the air spends in the carbon bed, the more it removes, which is why deep beds and low air speeds do better than thin beds at high speed. For a known gas, carbon can be impregnated to react with it. That is a different product from standard carbon, so name the gas when you enquire.

Fitting and replacement

Put a particle filter in front of the carbon. Dust, grease and oil coat the granules and block the pores, which ruins the capacity. A panel or bag filter upstream protects the carbon and is usually the cheapest improvement to its life. Where the contaminant is hazardous, a carbon filter is not a substitute for an engineered gas-phase system.

Where it is used

Where activated carbon filters are used.

  • Odour control in commercial kitchens, restaurants and food production, where cooking smells would otherwise leave through the extract or return to the room.

  • Fresh-air intake in cities and near roads

    Carbon takes traffic fumes and some gases from the incoming air so the occupied space smells clean.

  • Wastewater, waste handling and composting

    Odour from tanks, bins and process areas is adsorbed before the air is released.

  • Laboratories and chemical stores

    Fume and solvent vapours are held back from recirculated air, where the contaminant is known and sized for.

  • Museums, archives and clean areas

    Gaseous pollutants that damage paper, metal and electronics are adsorbed from the supply air.

Choosing

This type, or a different one.

Choose it when

Choose activated carbon when the problem is smell or a known gas: cooking odour, traffic fumes, solvents, waste odour. It is also used when the housing is designed for a carbon cell and you need a matching replacement.

Choose another type when

Choose a particle filter for dust, a HEPA filter for fine particles to a class, and a specialist gas-phase system where the contaminant is hazardous and the removal must be engineered and measured.

How to specify

Four details are enough to price a filter.

Send these four and a person can check the request. If one is missing, send what you have: a photo of the old filter and its label often fills the gaps.

  1. 01

    Size

    Width × height × depth in millimetres, for example 592 × 592 × 292. Measure the frame of the old filter or the opening it sits in. If the old filter has been squeezed into its slot, measure the slot. Standard and custom sizes are both possible, so send exact figures.

  2. 02

    Class

    Tell us the class you need (ISO 16890 or EN 1822). If your paperwork uses the older EN 779 names, such as G4 or F7, send those and we will match them. If you do not know the class, send the label of the filter you use now.

  3. 03

    Quantity

    How many of each size, and whether this is a one-off order or a regular one. A mixed list is fine, with one line per size.

  4. 04

    Application and airflow

    What the filter sits in, such as an air handling unit, a fan-coil unit, an oven or a cleanroom ceiling, and the airflow in cubic metres per hour if you have it. Add the temperature, the humidity and anything unusual in the air, such as grease, oil or chemicals.

A person checks every request. We tell you what matches, what differs and what we could not confirm, and we confirm the exact rating for your order.

Filter desk

Ask about activated carbon filters. A person replies.

The request form below is set to air filters and to this type. Give the size, the class and the quantity, add a photo of the old filter if you have one, and send it. A person reads every request, checks the details against the TAF range and replies by phone, WhatsApp or email.

Not sure this is the right type? Leave it as it is and say what the filter is for. We will tell you if another type fits better.

What do you need?

Send a part number or a photo of the rating plate. A person checks every request; this is not an automatic stock search.

Line stopped? Call first. We will pick up the request below too.

Robot part details
Rating plateoptional
Add a photo of the rating plateJPEG, PNG, WebP or HEIC, up to 8 MB.
More detail (optional)
Machining, cell or fixture details
Drawingoptional
Attach a drawingPDF, STEP, STP, DXF, DWG, PNG or JPG, up to 8 MB.
More detail (optional)
Air filter details
More detail (optional)

For example G4, F7 or H13.

Your details
Add a message

Files up to 8 MB. We use your details only to answer this request.

Questions

Activated carbon filters: common questions.

Does an activated carbon filter remove dust?

Not as its main job. Carbon removes gases, vapours and odours. Some constructions include a layer of media that catches particles too, but for dust you should still specify a particle filter, and place it upstream of the carbon so the dust does not clog it.

How long does a carbon filter last?

It depends on what is in the air and how much. A light odour load can last for months, and a heavy chemical load can exhaust a filter much sooner. We will not quote a life without the contaminant, the concentration and the airflow. If you can, send them, along with the filter you use now.

Can carbon filters be regenerated or cleaned?

Not in normal ventilation use. Spent carbon is replaced. Washing or heating a panel does not restore its capacity, and heating carbon in an air handling unit is unsafe. Plan for replacement and for correct disposal of the used filter.

What should I tell you for a carbon filter enquiry?

The gas or odour you are removing, how strong it is, the airflow, the temperature and humidity of the air, and the size of the housing. Without the contaminant we can only suggest standard carbon for general odour. With it, we can check whether a special carbon is needed.